IACER SRL MNPG05-07 Ed. 29/03/10 Pag. 38
Skip phase: press the button during the working program to skip to the next phase.
Pause/stop program: during the working program, press the button once to
momentarily pause the program. Press the button again to restart the program.
Switch off the machine to stop the program.
7. Battery charging.
The display shows when the battery is low of power. Insert the jack of the battery charger into
its socket and plug the battery charger into the main power socket.
Recharge for 8 hours for a complete charge.
Do dot immerge the battery in water or other liquids and do not expose it to heat sources.
Do not dispose of dead or defective batteries with domestic waste; dispose of in an authorised
waste collection bin.
Before storing T-ONE for long periods of time, we recommend that it is fully charged and
stored in a dry place, checking that it is switched off.
Do not use the battery charger if:
• The plug is damaged or parts of it are broken.
• It has been exposed to rain or any other type of liquid.
• The components have been damaged by a fall.
Do not immerge the battery charger in water. Use a dry cloth to clean the battery charger. Do
not open the battery charger: it does not contain repairable parts.
Warning: disconnect electrodes during recharchig.
8. T-ONE maintenance and storage.
T-ONE must be switched off and the cables removed from the connectors at the end of every
session. T-ONE should be kept in the carry bag supplied, together with its accessories, and
carefully stored on a secure surface and protected from situations listed in the Warnings
paragraph.
T-ONE should be stored in the following conditions:
Temperature: from -20°C to +40°C
Maximum relative humidity: 75%
Atmospheric pressure: from 700 hPa to 1060 hPa
Cleaning: only clean the device using a dry soft cloth.
We recommend a functional test carried out by the manufacturer every 24 months.
The manufacturer retains that the T-ONE device cannot be repaired by personnel external to
its own company. Any work of this nature carried out by personnel not authorised by the
manufacturer will be classed as tampering with the device, freeing the manufacturer from
responsibility for the warranty and hazards that the operator or user may be exposed to.
N.B. disconnect the cables before placing the electronic stimulator in the bag. If not, the cables
will bend excessively close to the connectors. This may damage the cables.
To Next Page
Loading...
