IBA KermaX-plus 120-131 HS E

Questions and Answers

K
Kaylee SmithAug 6, 2025
What to do if the IBA KermaX-plus 120-131 HS E indicate the wrong DAP value?
- M
  Michael MaldonadoAug 6, 2025
  If the indicated DAP value is wrong on your IBA Measuring Instruments, you should first check if the X-ray beam is correctly penetrating the chamber. Also, verify the field size setting and remove any additional filtration. Compare the indicated values with an independent dosimeter as described in the verification procedure. If these steps don't resolve the issue, the chamber may need to be returned to the factory for service and repair.
R
Rachel HatfieldAug 10, 2025
What to do if there is no DAP count during irradiation for IBA KermaX-plus 120-131 HS E Measuring Instruments?
- W
  wbrewerAug 10, 2025
  If there is no DAP count during irradiation with your IBA Measuring Instruments, verify the collimator opening. Also, check to ensure that the chamber is both connected and powered.
B
Brianna MelendezAug 14, 2025
How to troubleshoot a non-functioning interface on IBA KermaX-plus 120-131 HS E Measuring Instruments?
- J
  Jennifer GonzalezAug 15, 2025
  If the interface of your IBA Measuring Instruments is not functioning, start by checking the interconnections by disconnecting and reconnecting the cables. Then, check the power supply. Finally, verify the communication with another counter interface or display.
J
jeremiahgreenAug 19, 2025
Why am I getting a calibration error on my IBA Measuring Instruments?
- L
  Luke SummersSep 12, 2025
  If you encounter a calibration error with your IBA Measuring Instruments, check for any additional absorbers in the beam and remove them. Also, ensure that you are using the same beam quality as you used for the previous calibration.
C
Cody ChurchAug 23, 2025
What to do if IBA KermaX-plus 120-131 HS E Measuring Instruments are randomly counting without radiation?
- C
  cmayerAug 23, 2025
  If your IBA Measuring Instruments are randomly counting without radiation, check the chamber for humidity. If humidity is present, dry the chamber for 24 hours and then retry. Also, check for electrical interference; if necessary, contact a service engineer.
T
Taylor AllenAug 27, 2025
Why does the test value change on my IBA KermaX-plus 120-131 HS E?
- J
  Johnny RamirezAug 27, 2025
  If you observe changes in the test value on your IBA Measuring Instruments, verify whether the ambient temperature is too high or too low. Check the value again once the normal working temperature has been reached.
J
Jennifer CampbellSep 1, 2025
How to fix light field distortion on IBA Measuring Instruments?
- S
  Sherry WuSep 1, 2025
  If you notice light field distortion with your IBA Measuring Instruments, check the chamber plates for dirt and clean them according to the cleaning instructions.