Need help?Do you have a question about the Ibanez Tone Blaster 100R and is the answer not in the manual?
General| Power Output | 100 Watts |
|---|---|
| Effects | Reverb |
| Outputs | Headphone, Line Out |
| Speaker | 1x12" |
| Channels | 2 |
| EQ | 3-band EQ |
| Footswitch | Yes |
| Weight | 20 kg |
| Type | Solid State |
Guidelines for connecting an 8-ohm, 100W or greater speaker cabinet to the amplifier.
Instructions for connecting the power cable, guitar, and effects units.
Steps to achieve desired tones on the clean channel, including gain and volume adjustments.
Instructions for setting up and playing the overdrive channel, adjusting gain and volume.
Check cable connections and power outlet if the amplifier does not turn on.
Verify guitar connections, volume levels, and check for external device interference.
Inspect for resonating objects, loose cables, or external component noise.
Ensure footswitch is disconnected if front panel switches are not working.
Verify correct connection of the foot switch cable to the rear panel jack.
Confirm headphone connection and ensure volume is not set to zero.
Check speaker impedance matching and test with different equipment.
To Next Page
