IBC Technologies Inc.
1-844-432-8422 | www.ibcboiler.com
120-299E3 - August 23, 2023 - Released Document 2 of 5
When you purchase the kit from a wholesaler, you'll receive the following parts:
Fan Assembly - SL 40-399 G3, EX400, EX500
Part # Description Quantity
240-172 Fan, VG145 (EBM)
1
250-322 Heat Exchanger Gasket, Lid-fan 1
150-128 Nut, Hex M4 4
150-164 Screw, Zinc, M4 X 12 3
150-099 Washer, Flat, Stainless Steel, M4 3 3
150-073 O-ring, N70, Nitrile, 70 Mm X 3 Mm 1
900-012 Fan Detection Software USB V2.00.3 1
Note
A ladder or step may be required to have a clear vertical view of the work area.
Do not attempt to remove the assemblies without a clear view, as damage to the connectors or
screws may occur.
Fan removal
Preparing the Boiler for Servicing
1. Remove call(s) for heat.
2. Remove power to the boiler at a wall switch or a breaker.
3. Shut off gas supply to the boiler.
Do not drain the boiler unless freezing conditions are expected during this procedure.
4. Allow the boiler to cool down.
To Next Page
Loading...