iBeam TE-DGH User Manual

TE-DGH/TE-DGHC (CMOS)
RAM 1500 (2009-2017)
RAM 2500 (2010-2017)
Replacement Tailgate Handle
with Camera
Removal and Installation
Instructions
Tools Needed: T30 torx bit, ratchet, 8mm
socket.
1. Start by lowering the tailgate and remove
the (8) T30 torx screws from the bed liner,
remove liner (Fig. A), remove access panel
(Fig. B), and place aside.
2. Now that you have access to the handle
assembly, disconnect harness running to lock
actuator and unclip (2) latch rods. (Fig. C)
3. Next, remove (2) 8mm nuts located below
latch connectors, then slide latch assembly
aside. (Fig. C)
4. Gently remove handle by lifting the handle
from the outside and slowly working it out.
5. Now that the handle is out of the tailgate,
you will have to swap the locking mechanism
out of the old handle to the new one.
6. Start by removing the (2) 8mm screws from
locking mechanism, and then remove
mechanism from handle. (Fig. D)
7. Now place the locking mechanism in the new
handle and secure it with the factory 8mm
screws.
Fig. A
Fig. B
Fig. C

iBeam TE-DGH Specifications

General

Model	TE-DGH
Category	Automobile Accessories
Compatibility	Universal
Color	Black
Material	Plastic

Summary

Replacement Tailgate Handle with Camera Installation

Tools and Preparation

Gather tools and prepare tailgate by lowering it and removing bed liner and access panel.

Disconnect Handle Wiring and Rods

Disconnect the wiring harness to the lock actuator and unclip the latch rods.

Remove Old Handle and Transfer Mechanism

Remove the old handle, then swap the locking mechanism to the new handle.

Connect Camera Power and Routing

Splice camera power to reverse light, ground wire, and route RCA and trigger wires.

Install New Handle and Reconnect

Insert new handle, reattach nuts, reconnect lock actuator, and secure latch rods.

Complete Tailgate Reassembly

Reattach the tailgate's access panel and bed liner cover to finish the installation.