IBERITAL DE RECAMBIOS, S.A.
Page 16 of 22 manual electr.ce ingles 22-11-2004.doc
4) Stop pressing the buttons and turn Off (position 0) the On-Off switch
5) Turn On (position 2) the On-Off switch
1.6.- HOT WATER OUTPUT
Place a cup or other receptacle under the hot water jet (10). Push the button (9) to start the hot
water feed, release this button to stop it.
1.7.- STEAM OUTPUT
Point the steam jet (12) towards the drip tray (19).
Turn the control (8), to discharge the condensation, until steam escapes from the opening.
Place the steam jet (12) into the recipient containing the liquid which is to be heated. Turn the
control (8) to release the steam. To obtain a frothy cappuccino keep the jet level with the top
of the cold milk, this will create froth.
When the liquid has reached the desired temperature, stop the steam feed by turning the
control (8) on the contrary.
Slide the recipient out from under the steam jet (12). Point the stream jet (12) towards the drip
tray (19).
Briefly turn the control (8) to the right, to discharge any residue which has remained in the
steam jet (12). Clean the outside of the steam jet (12) with a damp clothe or sponge.
1.8.- DAILY CLEANING OPERATIONS
Cleaning the spray filters
To Next Page
Loading...
