Figure 12. Removing an adapter from the 5105-22E, 9008-22L, 9009-22A, 9009-22G, 9223-22H,
or 9223-22S system
e) Place the adapter on an approved ESD surface.
f) Repeat steps “3.a” on page 13 through “3.e” on page 15 for all of the PCIe adapters.
4. Remove the rear USB cable:
a) While pressing the latch release on the connector, unplug the rear USB cable (A) from the system
backplane as shown in the following gure. The connector on the system backplane that has the
USB port symbol with an arrow that points to the rear of the system.
Removing and replacing the system backplane in the 5105-22E, 9008-22L, 9009-22A, 9009-22G, 9223-22H,
or 9223-22S 15
To Next Page
Loading...
