Starting the ServeRAID Configuration Program
During an initialization process, the Write Policy area displays
the percent initialized; during a synchronization process, it
displays the percent synchronized.
6. The information area tells you the action you can perform on
this screen or pop-up.
Starting the ServeRAID Configuration Program
You can use the Administration and Monitoring program or the
ServeRAID configuration program to perform ServeRAID
configuration tasks.
You can dynamically view or change the configuration of your
server by using the Administration and Monitoring program from
your active operating system desktop. This means that you do not
have to restart the server. Refer to the README file on the Device
Driver/Administration and Monitoring diskette for instructions for
your operating system.
To start the ServeRAID configuration program from the ServeRAID
Configuration diskette, insert the diskette into the primary diskette
drive and turn on the system. If the system already is turned on,
press Ctrl+Alt+Del.
During the power-on self test (POST), the ServeRAID adapter checks
the configuration information on the adapter and on the hard disk
drives connected to it.
If POST does not detect problems or changes, the Main Menu
appears. See “The ServeRAID Adapter Main Menu” on
page 87.
If POST detects any change in the adapter configuration, a
configuration error message displays. See “ServeRAID Adapter
POST and Setup Messages” on page 331.
If POST detects an adapter hardware problem, an error message
displays. See “ServeRAID Adapter Status and Error Messages”
on page 335.
86 PC Server 520 User's Handbook for PCI/EISA
To Next Page
Loading...
