Using the PeerMaster Setup Utility Program
To run the configuration programs:
1. Insert the PeerMaster PCI Server Adapter Option Diskette into
drive A.
2. At the DOS command prompt, type A:\PSSETUP /config and
press Enter.
3. Select a specific PeerMaster adapter to configure.
The following example screen illustrates the configuration
information displayed by the /config parameter. For a description
of the PCI configuration registers, refer to the PCI BIOS 2.x
Specification.
PSSETUP: IBM Ethernet PCI PeerMaster Setup Utility V1.x
(c) Copyright 1995 Xpoint Technologies, Inc.
PCI BIOS Version Detected: 2.
PCI CONFIGURATION REGISTERS
Vendor ID nnnnn
Device ID nnnnn
Command nnnnn
Status nnnnn
Revision ID nnnnn
Class Code nnnnn
Cache Line Size nnnnn
Latency Timer nnnnn
Header Type nnnnn
BIST nnnnn
Memory Mapped Runtime Registers nnnnn
I/O Mapped Runtime Registers nnnnn
Base Address for Shared Memory nnnnn
Interrupt Line nnnnn
Interrupt Pin nnnnn
Minimum Grant Period nnnnn
Maximum Latency Period nnnnn
Continue with “Attaching Network Cables to Your Adapter” on
page 155.
154 PC Server 520 User's Handbook for PCI/EISA
To Next Page
Loading...
