Removing Internal Drives
Note: If you have a disk-array model, you must reconfigure
your disk arrays after you remove hard disk drives. See
“Starting the ServeRAID Configuration Program” on
page 86 for details.
6. What to do next?
If you are removing another hot-swap drive, return to step 1
on page 246.
If you are installing another internal drive in bank C, D, or
E, slide the drive vertically into the target bay until it
connects to the backplane, and move the knob on the drive
tray to the locked position. If you need details about
installing an internal drive, go to step 1 on page 205.
If you are not installing or removing another internal drive,
continue with the next step.
7. Go to Table 6 on page 384 and update the drive information;
then, return here to determine your next step.
Chapter 5. Installing Options 247
To Next Page