EISA Configuration Diskette
slots. The Add choice allows you to add ISA devices to the
configuration. If EISA adapters are installed in your server, and you
have not copied the .CFG file to the EISA Configuration Diskette,
you are prompted to insert the adapter configuration diskette into
the diskette drive. The .CFG file is copied to your diskette. If the
adapter .CFG file is copied to the EISA Configuration Diskette
before starting the diskette, and the adapter is installed in your
server, EISA devices are added automatically.
Step 3
View or edit details: After adding EISA or ISA adapters in Step 2,
use the Edit selection of this step to configure them. Use the Edit
Resources selection of this step for complex configurations. If you
change a setting in this step, you might have to change a switch or
jumper setting on the system board or on a device.
Step 4
Examine switches or print report: After Steps 1 and 2 have been
completed correctly, this step displays the correct switch and jumper
settings for the installed devices that have switches and jumpers.
Also, you can choose to print a system configuration report.
Step 5
Save and exit: This step allows you to save your configuration or
to discard the changes before you exit from the program.
Use the Up Arrow (↑) or Down Arrow (↓) key to highlight your
selection; then press Enter to make your selection. To help you
track your progress, a checkmark (√) appears on the main menu
next to the completed steps.
You can access help information through:
Help windows, which remain active.
Information windows, which appear automatically as a result of
some configuration activities.
296 PC Server 520 User's Handbook for PCI/EISA
To Next Page