POST Error Messages
POST Message Description
0173
0174
A change in device configuration occurred. This error occurs
under one or more of the following conditions:
A new device was installed
A device was moved to a different location or cable
connection
A device was removed
A device is failing and is no longer recognized by the
system as being installed
An external device is not turned on
Action: Verify that all external devices are turned on.
External devices must be turned on before the system
is turned on.
If you have just added, removed, or changed the location
of an EISA or an ISA adapter, start the EISA
Configuration Diskette and update the configuration
information. If the problem recurs, have the system
serviced.
If you have not just added, removed, or changed the
location of a device, run the test programs to identify the
failing device. Then have the system serviced.
0201 A memory error occurred during testing of the system board.
Action: Ensure that the memory modules are installed
properly. If the modules are properly installed, run the
test programs to determine the cause of the problem
and the action to take. If the test programs do not find
the problem, replace the failing memory module.
0295 Memory Size Mismatch, Memory has been added or removed
or is defective.
Action:
If you have just added or removed
memory-module kits, start the EISA Configuration
Diskette and update the configuration information.
If the problem recurs, call for service.
If you have not just added or removed
memory-module kits, run the test programs to
identify the failing memory module kit. Replace
the defective memory module kit, or call for
service.
Chapter 7. Solving Problems 327
To Next Page