IBM 520 - Page 397

Installed Device Records
Table 3. Setup Program Configuration Defaults and Changes
Option Default Value New Value Additional Information
Diskette A
Diskette B
1.44 MB, 3.5 in.
Not installed
Record additional drive information
in Table 6 on page 384.
Video System SVGA Record additional information in Table 4 on
page 380.
Video BIOS Shadow Enabled Select Disabled for adapters that cannot be
shadowed.
System Memory 640 MB
Extended Memory
Bank 0 Socket 1 16 MB Kit 16 MB Kit Ø 32 MB Ø
Bank 0 Socket 2 16 MB Kit 16 MB Kit Ø 32 MB Ø
Bank 1 Socket 3 16 MB Kit Ø 32 MB Ø
Bank 1 Socket 4 16 MB Kit Ø 32 MB Ø
Bank 2 Socket 5 16 MB Kit Ø 32 MB Ø
Bank 2 Socket 6 16 MB Kit Ø 32 MB Ø
Bank 3 Socket 7 16 MB Kit Ø 32 MB Ø
Bank 3 Socket 8 16 MB Kit Ø 32 MB Ø
Total Memory 32 MB
Cache State Enabled
COM1 Port 3F8
COM2 Port 2F8
LPT Port 378, IRQ 7
LPT mode Output only
Diskette controller Enabled
Large disk DOS
compatibility
DOS
Memory gap Disabled
Boot sequence A: then C: C: First will not check Drive A.
Swap diskettes Normal
Diskette check Disabled
SETUP prompt Enabled
Post Errors Enabled
Supervisor Password is Enabled
User Password is Disabled
Set Supervisor
Password
Press Enter Controls access to the Setup program.
Set User Password Press Enter Must set supervisor password first.
Password on boot Disabled
Diskette access User
Hard disk boot sector Normal
Appendix A. Server Records 379