Device Drivers
Network Adapter Device Drivers
If you are using OS/2 LAN Server and you want to install a
network adapter in your PC Server 520 that does not appear as a
selectable choice in the ServerGuide window box, use the following
instructions:
1. Use the information and instructions provided with the
ServerGuide package to install OS/2 and OS/2 LAN Server.
Note: If there are other products provided on ServerGuide that
you want to install, install them now.
2. When the list of network adapters appears in the window box,
select None.
Note: The IBM Ethernet extended industry-standard
architecture (EISA) Adapter and the IBM 16/4 Busmaster
EISA Adapter, which appear on the ServerGuide device
driver installation menus, are not supported in the IBM
PC Server 520. However, the IBM PC Server 520 does
support the IBM Auto LANStreamer PCI Adapter, which
is a replacement product.
3. When the installation has completed, restart the server.
4. Press Enter to bypass the BIND error messages.
Note: If you installed NetFinity, a driver could not be found
message might appear. Select OK to continue.
5. After the operating system loads, access MPTS (for OS/2 LAN
Server 4.0) or LAPS (for OS/2 LAN Server 3.0) and configure
your server with the appropriate network adapter device driver.
Note:
MPTS = Multiple Protocol Transport Services
LAPS = LAN Adapter Protocol Support
6. Go to the operating system prompt, then type:
COPY E:\GO4.CMD C:\
7. Press Enter.
32 PC Server 520 User's Handbook for PCI/EISA
To Next Page
Loading...
