Installing PeerMaster LAN Software
Installing Network Device Drivers
To install the network device drivers, create a subdirectory using the
DOS command. In the following examples we are using the
subdirectory name NETWARE.
1. Insert the PeerMaster Server Adapter Option Diskette into an
available diskette drive and change to the Novell NetWare
device driver directory, for example:
CD A:\NETWARE
2. Create a subdirectory on a DOS partition of your server hard
disk, for example:
C:\NETWARE
3. Copy the contents of the device driver directory on the
PeerMaster Server Adapter Option Diskette to the target
directory, for example:
COPY A:\NETWARE\. C:\NETWARE\.
The directory on the PeerMaster Server Adapter Option Diskette
contains the open data-link interface (ODI) device drivers for
your PeerMaster adapter, the latest versions of various Novell
NetWare NLM files, and several sample AUTOEXEC.NCF files.
Starting Novell NetWare
To start Novell NetWare:
1. Start your server and enter the command to start the Novell
NetWare server software. If your server is running Novell
NetWare Version 3.11, manually load the system file,
LSLENH.NLM.
2. Load the file from the DOS drive and directory into where the
device drivers from the PeerMaster Server Adapter Option
Diskette were copied, for example:
:LOAD C:\PATH\LSLENH
(where C: is the primary drive and PATH is
the directory)
The power-on self-test (POST) results are displayed at device driver
load time. POST failures typically indicate an installation or
40 PC Server 520 User's Handbook for PCI/EISA
To Next Page
Loading...
