powering on the printer
3Operator’s Guide
When you power on the printer, the
Power indicator lights and the printer
executes a power-on self-test. When
the test successfully completes, the
printer goes either to READY or NOT
READY state, depending on the menu
selection. In the READY state, the
READY indicator lights and the
message “READY” displays.
If there is a fault during the self-test,
the Attention indicator lights and a fault
message (such as “001 END OF
FORMS”) appears on the message
display. See page 76 for information
on fault messages.
READY
001 END OF FORMS
Ready
Power
Power
Attention
To Next Page
Loading...
