IBM 6400 - Coax Connection


12 Operator’s Guide
Line Feed
This key operates only in NOT
READY state. Press Stop to place
the printer in the NOT READY state.
(See page 15.)
In NOT READY state, press to
move the paper up one line, as
defined by the existing active line
spacing. Line Feed will repeat if it
is held down.
If there is any data in the buffer, it
will print, then the paper will move
up one line.

The data that prints is all of the data
contained in the printer buffer. The data in
the attachment buffer is not affected.
View
In NOT READY state, press to move
the paper’s existing print position up
to the tractor area for viewing. This
allows you to check the print location.
If there is any data left in the buffer,
the data will be printed, then the
paper will move up for viewing.
Press View a second time to move
the paper back to its previous print
position.

Pressing Start instead of pressing View a
second time moves the paper back to its
original print position, and puts the printer in
READY state.
Pressing Stop instead of pressing View a
second time moves the paper back to its
Line
Feed
View