IBM 6400 - Coax Code Dump Mode



15Operator’s Guide
Start
1) Moves the printer from NOT READY
state to READY state, enabled for
printing.
2) In program state, exits the menus
and places the printer in READY
state.
3) After pressing View or Eject to move
the print position to the tractor area,
moves the paper back to its original
print position, and places the printer
in READY state.
Stop
1) Moves the printer from READY state
to NOT READY state, enabled for
operator functions such as viewing
or changing configuration
parameters.
2) In program state, exits the menus
and places the printer in the NOT
READY state.
3) In fault state, clears the fault if the
problem has been corrected.
4) In the NOT READY state, pressing
Stop + Enter, which is a soft reset,
resets the printer to the power on
configuration.
5) After pressing View or Eject to move
the print position to the tractor area,
moves the paper back to its original
print position, and places the printer
in NOT READY state.
Start
Stop