17Operator’s Guide
Eject/Restore
(Standard Mode)
Standard mode is the only
eject/restore mode available on
Cabinet Models. For Pedestal Models
this mode can be selected from the
menu, and should be selected when
using the rear exit.
In Standard Mode, this key moves the
paper forward to facilitate tearing off the
paper at the perforation, then restores
the original paper position. In Top Exit
Tear Mode (selectable at the operator
panel only on the pedestal model), this
key restores paper to the top of the next
possible form.
In NOT READY state, press
Eject/Restore to move the paper
forward to the tear-off position toward
the back of the printer.
Once you have torn the paper at the
perforation, press Eject/Restore, Start,
or Stop to retract the paper to its
previous position, as described below:
• Eject/Restore moves the paper to
its previous position. The printer
returns to the mode it was in before
Eject/Restore was used.
• Start moves the paper to its
previous position and the printer
goes READY.
• Stop moves the paper to its
previous position and the printer
goes NOT READY.
If you are using this function to tear off
forms, you must press Form Feed before
using the Eject/Restore function. This will
help avoid unloading the paper as it is
restored to its original position.
Eject/
Restore
To Next Page
Loading...
