IBM 704 - Page 258

POST Error Messages
POST Message Description
0800 A PCI I/O Port Conflict occurred.
Action: Turn off the system and wait 30 seconds; then, turn it
back on. If the problem recurs, have the system
serviced.
0801 A PCI Memory Conflict occurred.
Action: Turn off the system and wait 30 seconds; then, turn it
back on. If the problem recurs, have the system
serviced.
0802 A PCI IRQ Conflict occurred.
Action: Turn off the system and wait 30 seconds; then, turn it
back on. If the problem recurs, have the system
serviced.
0803 The PCI Error Log is Full.
Action: Turn off the system and wait 30 seconds; then, turn it
back on. If the problem recurs, have the system
serviced.
0804 PCI ROM Not Found, May be OK For This Card: Bus nn,
Device nn, Function nn.
Action: None required. This message is for information only.
0810 A Floppy Disk Controller Resource Conflict occurred.
Action: Start the System Configuration Utility and check for
conflicts. If the problem recurs, have the system
serviced.
0811 A conflict occurred with the Primary IDE Controller Resource.
Action: Start the System Configuration Utility and check for
conflicts. If the problem recurs, have the system
serviced.
0812 A conflict occurred with the Secondary IDE Controller
Resource.
Action: Start the System Configuration Utility and check for
conflicts. If the problem recurs, have the system
serviced.
0815 A conflict occurred with the parallel port Resource.
Action: Start the System Configuration Utility and check for
conflicts. If the problem recurs, have the system
serviced.
240 PC Server 704 User's Handbook