Need help?Do you have a question about the IBM RS/6000 7025 F50 Series and is the answer not in the manual?
General| Category | Server |
|---|---|
| Operating System | AIX |
| Model | 7025 F50 |
| Processor | PowerPC |
| Number of Processors | 1 |
| Memory Type | ECC |
| Storage | SCSI |
| Form Factor | Tower |
| Architecture | PowerPC |
| Bus Architecture | Micro Channel |
Statement regarding FCC compliance for digital devices.
Statement regarding compliance with IEC Standard 950.
Safety requirements for UK telecommunications network connections.
Statement on EU electromagnetic compatibility directives.
Compliance statement for Canadian interference-causing equipment.
Statement regarding VCCI compliance for information technology equipment.
Statement regarding German EMVG compliance and radio protection.
Instructions for safe electrical connections and handling of equipment.
Information regarding laser safety for optical drives.
Information on the ISO 9000 quality system used in development.
List of related IBM publications for further information.
Diagrams and descriptions of system unit components and layout.
Explanation of system data flow and the typical boot process.
Technical specifications and operating environment requirements for the system.
Details on power cable types and specifications for different regions.
Procedure for performing a service inspection on the system.
Initial procedure to determine the starting point for problem analysis.
Procedure for analyzing failures and obtaining error codes.
Procedure specifically for diagnosing power-related problems.
Procedure for isolating defective FRUs using minimal configuration.
Procedures for analyzing continuous failures in SSA disk drive systems.
List of firmware and power-on self-test error codes.
Table mapping Service Request Numbers (SRNs) to FRUs.
Information on system checkpoints and Service Processor checkpoints.
Explanation of location codes and AIX mapping.
Description and usage of SSA service aids for problem determination.
Procedures for updating and maintaining system microcode.
Information on vital product data for system components.
Procedures for loading system diagnostics via different methods.
Using the graphical interface for system management tasks.
Overview of system utilities for configuration and information.
Setting and managing system passwords for security.
Configuring Remote Initial Program Load settings.
Viewing and changing SCSI controller addresses.
Procedures for updating and recovering system firmware.
Using text-based interface for system management.
Managing boot sequences and operating system selection.
Guidelines for safe handling of components and system access.
Procedures for removing chassis covers and I/O planar cover.
Step-by-step instructions for power supply servicing.
Procedures for removing and replacing CD-ROM, Tape, Diskette, and Disk Drives.
Instructions for servicing the system backplane.
Steps for removing and installing adapter cards.
Instructions for removing and replacing memory cards and modules.
Detailed steps for servicing the I/O planar.
Procedures for removing and replacing the CPU card.
Steps for removing and replacing the service processor.
Instructions for safe battery removal and replacement.
Procedures for removing and replacing system fans.
Procedures for servicing the operator panel display and control assembly.
Instructions for servicing the serial/parallel card.
List of system components, part numbers, and descriptions.
Information on SSA POSTs, error codes, and SRNs.
Guide to using SRNs for FRU identification.
Troubleshooting invalid SSA loop configurations.
How to access and navigate Service Processor menus.
Detailed discussion of Service Processor capabilities.
Various methods for powering the system on.
Information on system surveillance and heartbeats.
Procedures for updating Service Processor firmware.
Accessing and interpreting Service Processor error logs.
A checklist for setting up and configuring the Service Processor.
Procedures for testing Service Processor connectivity and configuration.
Provided sample configuration files for modems.
Guide to selecting the appropriate modem configuration file.
Instructions for modifying modem configuration files.
Explains Xon/Xoff, Ring Detection, and Terminal Emulators.
Strategies for modem recovery and preventing issues.
Initial phase when power is applied before full system power-on.
Phase where SP handles automatic duties and awaits requests.
Phase entered upon power-on, exiting upon OS loading.
Phase of SP tasks during steady-state OS execution.
To Next Page