The Identify Function
The identify function can be accessed from any of the service aids.
This function enables you to determine the location of a particular disk drive module
that you want to identify but do not want to remove from the system unit. The
identify function causes the check light of the disk drive module to flash for
identification (1 second on, 1 second off), but has no effect on the normal operation
of the disk drive module. You can use the identify function on any number of disk
drive modules at the same time.
Instructions displayed by the service aids tell you when you can select the identify
function.
Note: You cannot use the identify function on a device that is in reserved status.
Starting the SSA Service Aids
To start the SSA service aids:
1. Start the using-system diagnostics (see the
Common Diagnostics Information
Manual
), and go to DIAGNOSTIC OPERATING INSTRUCTIONS.
2. Follow the instructions to select FUNCTION SELECTION.
3. Select SERVICE AIDS from the Function Select menu.
4. Select SSA SERVICE AIDS from the Service Aids menu.
The SSA Service Aids menu is displayed.
┌────────────────────────────────────────────────────────────────────────────────┐
│ SSA SERVICE AIDS 8238 │
│ │
│ Move cursor onto selection, then press Enter. │
│ │
│ │
│ Set Service Mode │
│ Link Verification │
│ Configuration Verification │
│ Format Disk │
│ Certify Disk │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ │
│ F3=Cancel F1=Exit │
│ │
└────────────────────────────────────────────────────────────────────────────────┘
Chapter 3. Error Code to FRU Index 3-65
To Next Page
Loading...
Need help?
General