Call-Out:
During the setup, you entered your phone numbers for the Pager (on page B-19) and
Customer Voice (on page B-20). These numbers are used for this test.
1. Your remote terminal is disconnected as a result of the Call-In test.
2. Call your server again.
3. At the Service Processor Main Menu, select Call-In/Call-Out Setup menu, then
select Call-Out test. This causes a simulated error condition for the purposes of
this test.
4. After a few moments, a message appears regarding an illegal entry. Press Enter
to clear the message and return to the main menu.
5. When your telephone rings, answer the call. You should hear the sound of a
telephone being dialed. This is your computer trying to page you.
If this test is successful, call-out is working.
You now need to go back through the “Telephone Number Setup Menu” on page
B-18 to enter the actual telephone numbers your server will use for reporting
problems.
Appendix C. Service Processor Setup and Test C-3
To Next Page
Loading...
Need help?
General