The OK Prompt procvides access to the Open Firmware command prompt. The
Open Firmware command prompt is used for debug purposes, and device driver
development. Information about the commands that are available in the IEEE
Standard 1275.
The Multiboot Start option toggles between OFF and ON and selects if the Multiboot
menu invokes automatically on startup or not.
Select Boot Devices
This selection enables you to view and change the custom boot list, which is the
sequence of devices read at startup time.
à ð
Select Boot Devices
1. Display Current Settings
2. Restore Default Settings
3. Configure 1st Boot Device
4. Configure 2nd Boot Device
5. Configure 3rd Boot Device
6. Configure 4th Boot Device
7. Configure 5th Boot Device
.------.
|X=Exit|
------'
====>
á
ñ
Selecting the Display Current Settings option lists the current order of devices in the
boot list. The following screen shows an example of this display.
5-28 Service Guide
To Next Page
Loading...
Need help?
General