a Refer to “Exchanging the Hard Drive on the System Card” on
page 4-25 and perform Step 6 on page 4-26 to Step 9 on page 4-27.
b Reinstall the hard drive removed from the new card on the defective
card.
c Continue with Step 6.
6 Install the New System Card:
a Install the new system card. Make sure the card is aligned with the
plastic grooves and then slide it in until it is flush with the box. Hold the
locking latches so that they are perpendicular to the face of the system
card. With the card in full contact with the rear of the Multiaccess
Enclosure, press the locking latches into the system card.
b Tighten the thumbscrews on the face of the adapter card clockwise.
c Plug the PCMCIA token-ring from the defective system card to the new
system card.
d Plug the cables into the system card.
e Loosen thumbscrews on the SAC card.
f Unplug the SAC card from the board but keep it in its slot into the MAE.
g Power ON and verify the LEDs on the system card: The yellow LED of
the system card and the hard drive must be OFF.
4-10 3746-9X0: MAE Installation and Maintenance
To Next Page
Loading...
