Setting the Supervisory Password
If a supervisory password is set, the password must be entered prior being able to
access to the “System Management Services.” You must set a supervisory
password before operational code can be loaded in the multiaccess enclosure. The
multiaccess enclosure is initially shipped with a password of multiaccess
enclosure. This utility allows you to set and change the password.
1 Select 2. Set Supervisory Password from the utilities panel. The Set
Supervisory Password panel is displayed (Figure 5-8).
2 Type your new password and press Enter. You are prompted to enter your
new password again.
Note: The supervisory password can consist of from 1 to 8 characters with
no restrictions on which characters can be used.
Figure 5-8. Set Supervisory Password Panel
3 Type the password again and press Enter.
4 The Password Saved panel is displayed with the message that your
supervisory password has been saved.
5-12 3746-9X0: MAE Installation and Maintenance
To Next Page