Step 16
This step loads the Standalone Diagnostics. If you are unable to load the diagnos-
tics, go to “Step 7.”
1. Turn the power on.
2. Insert the diagnostic CD-ROM disc into the CD-ROM drive.
3. When the keyboard indicator appears, press F5 on the direct attached keyboard
or 5 on the ASCII keyboard to indicate that diagnostics are to be loaded.
4. Enter requested passwords.
5. Follow instructions to select a console.
Did the Diagnostics Operating Instructions display without any obvious display
problem?
NO Go to “Step 7.”
YES Go to “Step 9.”
Step 17
The diagnostics did not find a hardware problem. If you still have a problem, contact
your software support center.
Chapter 9. Hardware Problem Determination 9-9
To Next Page
Loading...
