IBM H SERIES RS/6000 - Page 260

timeout 6
done
disconnect:
delay 2 # Separate from previous data.
send "+++" # Assure command mode.
delay 2 # Allow mode switching delay.
send "ATHT\r" # Set modem switch-hook down
# (i.e., hang up).
ignore "\r" or "OK\r" timeout 2 # Ignore modem response.
send "ATEQ1\r" # Initialize modem: Echo OFF,
# Disable responses.
ignore "\r" timeout 1
done
condin: send "ATZQT\r" # Reset to factory defaults.
ignore "\r" or "OK\r\n" timeout 2 # Ignore modem response.
send "ATET\r" # Initialize modem: Echo OFF,
expect "\r" or "OK\r\n" timeout 2 # Enable responses (Numeric),
send "ATQVT\r" # Limit response codes.
expect "\r" timeout 2 # Confirm commands successful.
send "ATS=2\r" # Set AutoAnswer ON
expect "\r" timeout 2 # Confirm command successful.
done
waitcall: ignore "2\r" timeout 1 # Ignore first ring.
expect "2\r" timeout 1 # Pick up second ring
# or timeout.
# Expect a connection response.
expect "16\r" or "15\r" or "14\r" or "12\r" or "1\r" or "5\r" or "1\r"
timeout 6
done
page: send "ATDT%N,,,,%R;\r" # %N = pager call center number
# Add enough commas to wait for
# time to enter paging number.
# %R = paging number
# Confirm successful command.
expect "\r" timeout 6
delay 2 # Wait before hanging up.
send "ATHT\r" # Hang up.
expect "\r" timeout 2 # Confirm successful command.
done
ripo: send "ATZQT\r" # Reset to factory defaults.
ignore "\r" or "OK\r\n" timeout 2 # Ignore modem response.
send "ATET\r" # Initialize modem: Echo OFF,
expect "\r" or "OK\r\n" timeout 2 # Enable responses (Numeric),
send "ATQVT\r" # Limit response codes.
expect "\r" timeout 2 # Confirm commands successful.
send "ATS=\r" # Set AutoAnswer OFF
expect "\r" timeout 2 # Confirm command successful.
done # RI Power On enabled.
error: # Handle unexpected modem
# responses.
expect "8\r" or "7\r" or "6\r" or "4\r" or "3\r"
delay 2
done
C-16 RS/6000 Enterprise Server Model H Series User's Guide