– FC 5033 - part 21H9364
– FC 5034 (as installed) - part 21H9364 or part 44H7779
– FC 5035 - part 44H7779
Note: FC 5035 may contain up to 4 power supplies. The reference code that sent you here refers
to the power supply on the base expansion unit. See Expansion Unit Locations and Addresses in
the Migrated Expansion Tower Problem Analysis, Repair and Parts manual on the V5R1
Supplemental Manuals web site
.
This ends the procedure.
11.
Is the SRC 1xxx 2330 or 2331?
v No: Continue with the next step.
v Yes: The failing item is power supply 1 on a base expansion unit:
– FC 5033 - part 21H9364
– FC 5034 (as installed) - part 21H9364 or 44H7779
– FC 5035 - part 44H7779
Note: FC 5035 may contain up to 4 power supplies. The reference code that sent you here refers
to the power supply on the base expansion unit. See Expansion Unit Locations and Addresses in
the Migrated Expansion Tower Problem Analysis, Repair and Parts manual on the V5R1
Supplemental Manuals web site
.
This
ends the procedure.
12. Is the SRC 1xxx 2213?
v No: Continue with the next step.
v Yes: See the next failing item.
This ends the procedure.
13.
Is the SRC 1xxx 2210?
v No: Continue with the next step.
v Yes: The failing item is power supply 1 on the base expansion unit, or power supply 2 on the
internal expansion unit of an FC 5035 expansion.
– FC 5033 - part 21H9364
– FC 5034 (as installed) - part 21H9364 or 44H7779
– FC 5035 (power supply 2) - part 44H7779
This ends the procedure.
14.
Is the SRC 1xxx 2610?
v No: Go to “Starting point for all problems” on page 2.
This ends the procedure.
v Yes: Check the memory cards (2) and processor card for correct installation and that it is seated
properly. If the SRC prevails, replace the following one at a time (see Locations and addresses ):
– Power supply
– Memory cards
– Processor card
This ends the procedure.
Instructions for Models 800, 810, 825, 870/890 (FC 9094)
Analyze hardware problems 435
To Next Page
Loading...
Need help?
General