Failing item code Description/Action
FI00316 FI00316 indicates that no I/O processors were found on the bus.
Verify the configuration information for the system. If a bus is configured to be empty, there
is no problem.
FI00317 FI00317 indicates that the I/O processor cards at consecutive direct select addresses
appear to be failing.
The I/O processor cards or a damaged backplane could cause this problem.
FI00318 FI00318 indicates that an I/O adapter card attached to an I/O processor card on the failing
bus is the failing item.
FI00319 FI00319 indicates that the Licensed Internal Code on an I/O processor is the failing item.
Install a PTF to correct the problem.
Ask your next level of support for assistance.
FI00320 FI00320 indicates that the display station used as the console is the failing item.
FI00350 For Models 830, 840, SB2, and SB3 only, FI00350 indicates that the alternate IPL device is
the failing item.
See the service information for the specific device type and model installed on the system to
determine the part.
FI00360 FI00360 indicates that the IPL disk device is the failing item.
FI00380 On the bus with the system console or the failing logical partition’s console the failing item is
the first workstation IOP card or the workstation IOA card. The bus with the system console
is bus 0001. For systems with multiple logical partitions the Primary partition’s console is on
bus 0001 and the consoles for other logical partitions are determined by the LPAR
configuration.
FI00500 See FI01140 (See page 267)
FI00580 FI00580 indicates that any storage device may be the failing item.
The address of the failing storage device cannot be determined.
FI00581 FI00581 indicates that a storage device at the address identified by the problem isolation
procedures for the reference code is the failing item.
Use the service information of the I/O device to continue analyzing the problem.
FI00584 FI00584 indicates that any storage device may be the failing item.
The address of the failing storage device cannot be determined.
FI00601 FI00601 indicates that the display station is the failing item.
If a link protocol converter is used to connect the console to the system, the protocol
converter is the failing item.
FI00602 FI00602 indicates that the cable between the workstation attachment and the device is the
failing item.
FI00603 FI00603 indicates that the 5299 multiconnector is the failing item.
FI00604 FI00604 indicates that a printer is the failing item.
Use the printer device information to analyze the problem.
FI00605 FI00605 indicates that a magnetic stripe reader on a display station is the failing item.
FI00606 FI00606 indicates that the storage media is the failing item.
FI00607 FI00607 indicates that a selector light pen attached to a display station is the failing item.
FI00608 FI00608 indicates that the link protocol converter is the failing item.
Analyze hardware problems 257
To Next Page
Loading...
Need help?
General