IBM iSeries 820 Hardware Problem Analysis And Isolation

Use the Service Action Log to find system reference codes associated with the missing disk units by
changing the From: Date and Time on the Select Timeframe display to a date and time prior to when the
user attempted to vary on the IASP. For information on how to use the Service Action Log, see “Use the
service action log” on page 7.
This
ends the procedure.
000B: Some system IOPs require cache storage be reclaimed.
1. Start SST.
2. Reclaim the cache adapter card storage by performing the following:
a. Select Work with disk units —> Work with disk unit recovery —> Reclaim IOP Cache
Storage.
b. Follow the on-line instructions to reclaim cache storage.
c. After you complete the repair, the system operator may want to restore data from the most recently
saved tape.
This ends the procedure.
000D:
The system disk capacity has been exceeded.
For more information about disk capacity, see the iSeries Handbook.
This ends the procedure.
000E: Start compression failure.
1. Select Manual mode and perform an IPL to DST. See Performing an IPL to DST in the iSeries Service
Functions information.
2. Correct the problem by doing the following:
a. Select Work with disk units —> Work with disk unit recovery —> Recover from start
compression failure.
b. Follow the on-line instructions.
This ends the procedure.
002C:
A Licensed Internal Code program error occurred.
Ask your next level of support for assistance.
This
ends the procedure.
002D: The IASP configuration source disk unit data is down-level.
The system is using the IASP configuration source disk unit that does not have the current level of data.
Work with the customer to recover the configuration. On a workstation with iSeries Navigator installed,
select the disk pool with the problem, and then select Recover configuration.
This
ends the procedure.
002E: The Independent ASP is assigned to another system or a Licensed Internal Code program error
occurred.
Work with the customer to check other systems to determine if the Independent ASP has been assigned to
it. If the Independent ASP has not been assigned to another system, ask your next level of support for
assistance.
This
ends the procedure.
002F: The system version and release are at a different level than the IASP version and release.
Analyze hardware problems 137

IBM iSeries 820 Specifications

General

Brand	IBM
Model	iSeries 820
Category	Server
Language	English