IBM iSeries Series Analyze Hardware Problems (System Reference Codes

Reference Code Description/Action Perform all actions before exchanging Failing Items Failing Item
8012 Attached read cache devices exceed capacity supported by IOA
Reduce the number of read caches on the IOA.
SVCDOCS
8100 I/O processor Licensed Internal Code error AJDGP01
IOP
8130 IOA detected recoverable device bus error
An error occurred on SCSI bus 0. No action is required. This reference code
is logged for information only.
8131 IOA detected recoverable device bus error
An error occurred on SCSI bus 1. No action is required. This reference code
is logged for information only.
8132 IOA detected recoverable device bus error
An error occurred on SCSI bus 2. No action is required. This reference code
is logged for information only.
8133 IOA detected recoverable device bus error
An error occurred on SCSI bus 3. No action is required. This reference code
is logged for information only.
8140 IOA detected recoverable device bus error
No action is required. This reference code is logged for information only.
8141 IOA detected recoverable device error
No action is required. This reference code is logged for information only.
8145 A recoverable I/O processor error occurred. STORIOA
8146 Disk device detected recoverable error FI01105
8150 A permanent I/O processor failure occurred STORIOA
ANYBRDG
8151 I/O processor Licensed Internal Code error AJDGP01
STORIOA
8155 to 8156 A permanent I/O processor failure occurred AJDGP01
STORIOA
8157 I/O adapter card error
Display the Service Action Log entry for this SRC. If the Failing Item
indicates I/O adapter, then replace the I/O adapter. If the Failing Item
indicates SVCDOCS, then do NOT replace the I/O adapter. This is a
recoverable error. Perform the following for the I/O processor that the I/O
adapter is attached to:
1. If the I/O Processor is not operable and disk units are attached, use
Hardware Service Manager to re-IPL the IOP. Other resources attached to
the IOP may then need to be Varied On.
2. If disk units are not attached, perform the VRYCFG RESET(*YES)
command to reset the IOP and Vary On attached resources.
SVCDOCS
8200 I/O processor Licensed Internal Code error AJDGP01
IOP
9000 I/O processor card detected device error FI01105
STORIOA
2748, 2757, 2763, 2778, 2782, 5703
142
iSeries: iSeries 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Analyze Hardware Problems (System Reference
Codes)

IBM iSeries Series Specifications

General

Brand	IBM
Model	iSeries Series
Category	Server
Language	English