.16/ Two Diskette Drive Ribbon Cables
.17/ Diskette Drive and Drive Mounting Bracket
.18/ Standby Battery
.19/ Battery Shield
.2ð/ Backup Battery
.21/ Adapter Bezel
.22/ One Screw (F)
(In corner of serial/modem card)
.23/ Serial/Modem Card
.24/ Two Screws (F)
(At front edge of hard disk drive)
.25/ Two Ribbon Cables and Hard Disk Drive
(Have customer backup all information on hard disk
drive before removal.)
.26/ External Adapter and Battery Doors
.27/ Eight System Board Screws (F)
.28/ One Screw (C)
(Inside right-rear access door)
.29/ Two Threaded Hex Spacers
(Inside right-rear access door)
Remaining System Board Cables
.3ð/ System Board
(When replacing system board, install old memory
module kits and math coprocessor on new system
board. Run Automatic Configuration using
customer's backup Reference Diskette.)
.31/ Speaker
40 IBM Mobile Systems HMM - Volume 1
To Next Page
Loading...
