IBM Nortel Networks L2/3 - Page 128

114 Nortel Networks L2/3 Ethernet Switch Module for IBM Eserver BladeCenter
Example 7-22 Layer 3 VLANs and ports for Core switches
Configuration for Core1 (address .245)
! first of all enable layer 3, disable STP/PVST, clean up unused
ip routing
no spanning-tree vlan 1-4094
no vlan 10
no vlan 20
no vlan 5
!
! assign ports and VLANs
interface range g0/1-2
channel-group 1 mode on
interface range Po1, g0/1-2
switchport access vlan 35
switchport mode access
interface range g0/11-12
channel-group 2 mode on
interface range Po2, g0/11-12
switchport access vlan 35
switchport mode access
interface vlan 35
ip address 10.35.0.245 255.255.255.0
Configuration for Core2 (address .246)
! first of all enable Layer 3, disable spanning tree, clean up
ip routing
no spanning-tree vlan 1-4094
no vlan 10
no vlan 20
no vlan 5
!
interface range g0/1-2
channel-group 1 mode on
interface range Po1, g0/1-2
switchport access vlan 46
switchport mode access
interface range g0/11-12
channel-group 2 mode on
interface range Po2, g0/11-12
switchport access vlan 46
switchport mode access
interface vlan 46
ip address 10.46.0.246 255.255.255.0