IBM Nortel Networks L2/3 - Page 153

Chapter 7. Nortel Networks L2/3 GbESM configuration and network integration 139
/c/l3/vrrp/vr 2
ena
vrid 2
if 20
prio 101
/* -- above only on GbESM 1
addr 10.20.0.100
/* the section below is for RIP - remove it for OSPF
/* for GbESM2 use if 45 and 46 instead of 35 and 36 in the section below
/c/l3/rip/updat 30/on
/c/l3/rip/if 10/ena/supply e/listen e/default listen/version 2
/c/l3/rip/if 10/poison d/trigg e/metric 1/mcast e
/c/l3/rip/if 10/auth none
/c/l3/rip/if 20/ena/supply e/listen e/default listen/version 2
/c/l3/rip/if 20/poison d/trigg e/metric 1/mcast e
/c/l3/rip/if 20/auth none
/c/l3/rip/if 35/ena/supply e/listen e/default listen/version 2
/c/l3/rip/if 35/poison d/trigg e/metric 1/mcast e
/c/l3/rip/if 35/auth none
/c/l3/rip/if 36/ena/supply e/listen e/default listen/version 2
/c/l3/rip/if 36/poison d/trigg e/metric 1/mcast e
/c/l3/rip/if 36/auth none
/
/* the section below is for OSPF - remove it for RIP
/c/l3/ospf/on
/c/l3/ospf/aindex 1
ena
areaid 0.0.0.9
type transit
metric 1
auth none
spf 10
/c/l3/ospf/if 10
ena
aindex 1
prio 1
cost 1
hello 10
dead 40
trans 5
retra 5
/c/l3/ospf/if 20
ena
aindex 1
prio 1
cost 1
hello 10
dead 40
trans 5
retra 5
/c/l3/ospf/if 35
/* use if 45 instead of 35 for GbESM 2
ena
aindex 1
prio 1
cost 1
hello 10
dead 40