8.12
Open a terminal session on the PC, using an application such as
HyperTerminal, and wait for the SM’s menu to appear. Be sure the line speed
is set to 19,200 bits per second to communicate with the system.
8.15
Change the partition mode.
Insert the Virtual I/O Server CD into the optical drive of the system.
1.
2.
3.
4.
5.
In the navigation area, expand .
Click .
Select in the AIX/Linux partition mode boot field.
Select in the Boot to system server firmware field.
Click .
Power/Restart Control
Power On/Off System
Boot to SMS menu
Running
Save settings and continue system server firmware boot
8.13
1.
2.
3.
4.
In the ASMI navigation area, expand .
Click .
Select in the AIX/Linux partition mode boot field.
Click .
Power/Restart Control
Power On/Off System
Continue to operating system
Save settings
8.14
Change the partition mode back so that the server continues to load the operating
system during startup.
8.11
After the system has reached the firmware standby state, enter the activation
code for the Virtualization Engine technologies.
TM
In the navigation area, expand .
Click .
Enter the activation key into the field. This key was included with the printed
material inside your system box.
Click . The Advanced POWER Virtualization feature is enabled.
On Demand Utilities
CoD Activation
Continue
1.
2.
3.
4.
To Next Page
Loading...
