IBM PCjr - Page 368

Fuse-FUter Card/Power Cord Removal 1452
1. Set printer POWER switch to OFF; unplug power
cord from waUoutlet and discoimect printer cable.
2. Remove forms.
3. Remove forms rack (1440).
4. Remove access cover (1430).
5. Remove top cover (1432).
DANGER
STATIC VOLTAGE MAY BE PRESENT
ON THE FUSE-FILTER CARD. USE
CAUTION IN THIS AREA.
6. Remove safety shield from fuse-filter card assembly
(1496).
7. Remove transformer primary cormector 0 from
fuse- filter card.
8. Remove screw 0 from center of fuse-filter card.
9. Remove screw 0 from ground terminal of printer
power cord.
10.Lift strain relief 0 fromslotin base cover.
11. Lift fuse-filter card from slot in base cover.
4-1400-36 Graphics Printer