Figure 20. Disconnecting the front USB cable and routing it over the side of the system
6. Remove the service processor card:
a) At the rear of the system, unlatch the PCI adapter retainer (A) for the service processor card as
shown in Figure 21 on page 24.
b) Pull the service processor card straight up from the slot by holding the two card holder brackets
(B) at the front and rear of the card as shown in the following gure.
Removing and replacing the system backplane in the 9009-41A, 9009-42A, or 9223-42H
23
To Next Page
Loading...
