Figure 19. Removing the rear USB cable
b) At the rear of the system, press on the tabs (B) in the direction that is shown in the previous gure
to release the rear USB cable (C).
c) Lift the rear USB cable out of the system.
d) Place the rear USB cable on an appropriate ESD surface.
5. Disconnect the front USB cable from the system backplane.
a) Pressing the latch release on the connector, disconnect the front USB cable (A) from the system
backplane as shown in the following gure. The connector on the system backplane that has the
USB port symbol with an arrow that points to the front of the system.
b) Unfasten the cable from the hook and loop fasteners that secure the cable to the right side of the
chassis.
c) Route the cable over the side of the system and out of the way to provide clearance for removing
the backplane.
22
Power Systems: System backplane
To Next Page
Loading...
