Figure 18. Removing a PCIe adapter from a 9009-41A, 9009-42A, or 9223-42H rack-mounted
system
e) Place the adapter on an appropriate ESD surface.
f) Repeat steps “3.a” on page 19 through “3.e” on page 21 for the remaining adapters.
4. Remove the rear USB cable:
a) While pressing the latch release on the connector, unplug the rear USB cable (A) from the system
backplane as shown in the following gure. The connector on the system backplane that has the
USB port symbol with an arrow that points to the rear of the system.
Removing and replacing the system backplane in the 9009-41A, 9009-42A, or 9223-42H
21
To Next Page
Loading...
