Figure 28. Removing the rear SAS cable adapter
f) Place the rear SAS cable and connector on an appropriate ESD surface.
g) Twist the screws (A) counterclockwise to release the SAS RAID adapter. Lift both the SAS RAID
adapter and the front SAS cable out of the slot. Ensure that the front SAS cable does not catch on
any components while you are lifting the SAS RAID adapter out of the slot.
See the following gure.
Removing and replacing the system backplane in the 9009-41A, 9009-42A, or 9223-42H
31
To Next Page
Loading...
