Figure 29. Removing the SAS RAID adapter
h) Place the SAS RAID internal adapter on an appropriate ESD surface.
i) Repeat steps “9.a” on page 28 through “9.h” on page 32 for any additional SAS RAID adapters.
10. Remove the NVMe M.2 carrier card, if present. Otherwise, continue with step “11” on page 33.
a) Twist the screws (A) counterclockwise to release the NVMe M.2 carrier card.
b) Lift the NVMe M.2 carrier card out of the slot as shown in the following gure.
32
Power Systems: System backplane
To Next Page
Loading...
