Figure 30. Removing the NVMe M.2 carrier card
c) Place the NVMe M.2 carrier card on an appropriate ESD surface.
11. Remove the internal RDX docking station, if present. Otherwise, continue with step “12” on page
35.
a) Disconnect the RDX power cable (A) from the back of the RDX docking station and route the cable
over the side of the system as shown in the following gure.
b) Disconnect the front USB cable (B) from the back of the RDX docking station and route the cable
over the side of the system as shown in the following gure.
Removing and replacing the system backplane in the 9009-41A, 9009-42A, or 9223-42H
33
To Next Page
Loading...
