g) Grasp the system backplane by positions (A) and (B) on the front and middle metal bulkheads and
lift up until the pins disengage from the bottom of the chassis. See the following gure.
Figure 60. Grasping the system backplane and disengaging the pins
h) Tilt the system backplane so that the front end is high and the back end is low as you continue to
lift the system backplane out of the chassis. When the system backplane catches on the pins (A)
on the power supply cage, slide the system backplane forward until it clear the pins. Then, lift the
system backplane completely out of the system. See the following gure.
62
Power Systems: System backplane
To Next Page
Loading...
