IBM Proprinter

If you are using page formatting, you need to correctly set
the top of form. See "How to Set the Top of Form" on
page 3-28.
Programming Problems
Program commands from your computer control the
printer. If your printer problem only occurs during a
particular program, look at the program. Look for control
codes or escape sequences that might cause the problem.
Check the switch settings. See "How to Change a Switch
Setting" on page 6-4.
Additional Information
Read the Proprinter Technical Reference for additional
information about control codes, escape codes, and
programming examples.
If you need additional help with setup or operation,
contact an IBM Authorized Dealer, an IBM Product
Center, or the IBM Branch Office serving your locality.
Service
Contact (or ship your printer to) an IBM Authorized
Dealer or an IBM Service/Exchange Center. See "What
To Do When the Printer Needs Repair" on page A-1. Do
not try to repair the printer yourself.
Operator Note!
Before you ship the printer to an IBM
Service/Exchange Center, remove and keep:
Ribbon cartridge
Power cord
Printer cable
5-21