h. Remove the cover:
1) Loosen the six screws in the recessed holes on the back of the cover.
Note: The screws stay in place; do not attempt to remove them.
2) Grasp the sides of the cover, pull it back slightly, then tilt it back a few
inches.
3) Grasp the cover at the top front edge with one hand, and just above the
I/O slots with the other hand.
4) Remove the cover gently, in a rotating motion, as shown.
5) Store the cover in a safe place.
Chapter 7. Removal and Replacement Procedures 7-5
To Next Page
Loading...
