Power Supply
DANGER
Do not attempt to open the covers of the power supply. Power supplies
are not serviceable and are to be replaced as a unit.
Removal
1. If you have not already done so, remove the covers as described in “Covers” on
page 7-3.
2. Disconnect all leads from the power supply to the drives in bays 1 through 8.
3. Disconnect all leads from the power supply to the system planar.
4. While supporting the power supply with one hand, remove the four screws
securing the power supply to the rear of the system unit.
115 115
Power Supply
Screws
Chapter 7. Removal and Replacement Procedures 7-7
To Next Page
Loading...
