Media Drive in Bays 3 through 8
CAUTION:
A class 3 laser is contained in the device. Do not attempt to operate the drive
while it is disassembled. Do not attempt to open the covers of the drive as it
is not serviceable and is to be replaced as a unit.
Removal
1. If you have not already done so, remove the covers as described in “Covers” on
page 7-3.
2. Remove the cover plate from the target bay if installed:
a. Insert a small flat-blade screwdriver under the side of the cover plate.
b. Lift the cover plate and remove it from the server's front panel. (Save the
cover plate for future use.)
3. Complete the following steps:
a. Find the drive you plan to remove.
b. Disconnect the cables (signal and power) from the rear of the drive.
c. If you are removing a 3.5-inch drive, remove the screws that hold the drive
tray in place. Then remove the drive from the tray.
d. If you are removing a 5.25-inch drive, slide the drive out of the bay.
Chapter 7. Removal and Replacement Procedures 7-9
To Next Page
Loading...
