Chapter 2. Maintenance Analysis Procedures (MAPs)
Entry Map
Use the following table to determine your starting point.
Note: When possible, run Online Diagnostics in Service Mode. Online Diagnostics
perform additional functions, compared to Standalone Diagnostics. This will
ensure that the error state of the system is captured in NVRAM for your use
in fixing the problem. The AIX error log and SMIT are only available when
running online diagnostics.
Symptom Starting Point
You have a problem that does not prevent the
system from booting.
Go to the Fast Path MAP in the
IBM RS/6000
Diagnostic Information for Multiple Bus Systems
.
You do not have a symptom. Go to MAP 0020 in the
IBM RS/6000 Diagnostic
Information for Multiple Bus Systems
You have an SRN. Go to the Fast Path MAP in the
IBM RS/6000
Diagnostic Information for Multiple Bus Systems
.
The system stops and a 3-digit number is
displayed in the operator panel display.
Record SRN 101-xxx, where xxx is the 3-digit
number displayed in the operator panel display,
then go to the Fast Path MAP in the
IBM RS/6000
Diagnostic Information for Multiple Bus Systems
.
You have an 8-digit error code. Go to “Quick Entry MAP” on page 2-2.
The system will not boot. Go to “Quick Entry MAP” on page 2-2.
Chapter 2. Maintenance Analysis Procedures 2-1
To Next Page
Loading...
