Symptom Action
Only a short beep, disk activity indicator LED is
OFF, and no POST indicators are displayed.
Go to “MAP 1540: Minimum Configuration” on
page 2-18.
The system appears to be stopped and the disk
activity indicator LED is ON continuously and a
beep was NOT heard from the system unit.
Record error code M0MEM000, then go to “Step
1020-3” on page 2-10.
The system appears to be stopped and the disk
activity indicator LED is ON continuously and a
beep was heard from the system unit.
Record error code M0MEM001, then go to “Step
1020-3” on page 2-10.
The System Management Services menu is
displayed.
Go to “Step 1020-4” on page 2-11.
The system stops and POST indicators are
displayed.
Go to “MAP 1540: Minimum Configuration” on
page 2-18.
The diagnostics are loaded and there was no
beep heard from the system unit during the IPL
sequence.
Record error code M0SPK001, then go to “Step
1020-3” on page 2-10.
The system does not respond when the
password is entered.
Go to “Step 1020-2” on page 2-10.
The system stops and the message "STARTING
SOFTWARE PLEASE WAIT..." is displayed or
only a cursor is displayed.
Go to “MAP 1540: Minimum Configuration” on
page 2-18.
The system stopped and a POST indicator is
displayed on the system console and an
eight-digit error code is not displayed.
If the POST indicator represents:
a keyboard, record error code M0KBD000.
boot disk, record error code M0HD0000.
memory, record error code M0MEM002.
a diskette drive, record error code
M0FD0000.
SCSI, record error code M0CON000.
Go to “Step 1020-3” on page 2-10.
Chapter 2. Maintenance Analysis Procedures 2-9
To Next Page
Loading...
